Source: Ningbo Eagle Intelligent Technology Co., Ltd

The vibration chassis is an automatic sorting feeding device.
The composition of the vibration plate: hopper, chassis, controller, linear feeder.
Automatic feed vibration chassis is an automatic orientation of the feeding device. The purpose of its work is through the vibration of the workpiece will be ordered in an orderly and orderly, accurate delivery to the next process. In addition to product sorting can also be used for sorting, testing, counting packaging, is a modern high-tech products. How the vibrating chassis works: There is a pulsed electromagnet under the hopper that allows the bucket to vibrate vertically. The spring is tilted so that the hopper vibrates around its vertical axis. The parts of the hopper, due to this vibration, rise along the spiral track until they are sent to the discharge port. Vibration chassis of the electrical control box fuse to protect the role of vibration chassis is connected with the electrical control box vibration plate electrical plug, turn on the power, open the switch, slowly turn the potentiometer, and gradually reach the required number of feeding can be.
The last note should be in the boot before the potentiometer must be transferred to the lowest value, so as not to damage the SCR, solenoid coil temperature is high or burn the coil 2 points:
    1, between the electromagnetic and the armature is too large, easy to burn the coil;
    2, to adapt to the full-wave vibration of the electromagnet If the half-wave power supply will appear when the temperature is high, turn on the power does not vibrate, to check the electrical controller fuse is broken, electrical components are loose, plug socket is bad.
If the delivery speed can not meet the requirements and pay attention to the following three points; 1, check the fastening of the elastic components of the screws are loose; 2, the spring is broken;
      3, the electromagnetic gap is too large, the normal gap corresponding to the small vibration plate of the electromagnet and armature spacing in the 0.5MM to 1.2MM range. Core and armature face unevenness is not greater than 0.02MM.

Recommended products Keywords: Cixi vibration plate Ningbo vibration plate non-standard vibration plate